Please inspecting all the following points before using the machine
Inspecting the “emergency stop” switch on the paper feeding table When you press down the “emergency stop” switch, please shut down the machine immediately, then the “on” light will be off. When the “emergency stop” switch is locked. Please don’t start the machine. The “on” light will be on after the release of the “emergency stop” switch.
Inspecting the top cover of the delivery belt. When the top cover opens, the machine stop immediately. ”security top cover open” light is on. When the top cover opens, please don’t start the machine. ”security top cover open “light is off after closing the top cover.
Inspecting the security switch of the shred box. The machine will stop immediately when you take out the shred box. ”security top cover open” light is on. Please do not start the machine, when you are taking out the shred box. The “security top cover open” light will be off after you reinsert the shred box.
Inspecting the security switch of the checking door When open the checking door, the machine stops immediately. ”shred box full” light is on, close it, the light is off.
Common problems and solutions
Inspecting the tightness of the delivery belt could not skid when the paper on it. The paper on the belt should be delivered steadily, The delivery belt skid, please adjust as follows:
Shut down, take out the paper feed table, then will see the tightness of the delivery belt
Loosen the screw of tightness pulley
Tighten the screw to adjust the tightness of delivery belt
It only exert pressure to the skidding point when tighten the delivery belt. tighten the delivery belt over will damage the bearing of delivery belt
Tighten the screw of tightness pulley again
Reinstall the paper feeding table
Inspecting the abrasion of delivery belt It will cause abrasion after a long time work .when the weave of the belt can be saw, you should replace the belt.
Inform of the sale-after service department
Replace the delivery belt
Cleaning the delivery belt Inspect the delivery belt once a month
Shut down
Remove paper feeding table and control panel front of tightness belt.
Cleaning dust and waste
Reinstall paper feeding table and control panel
Inspecting the tightness of chain belt Inspecting the new machine once a week in the first month, then once a month
Shut down
Remove left cover
The chain must droop 4mm to 10 mm When the tightness of chain need tighten
Loosen the tightness screw until the chain droop up to 4mm to 10 mm
Tighten the screw
Put left cover in original place
Paper shredder system
Do below things everyday
Spurt the lubricant on the shred roller through paper feeding portal
Drive the shred system without paper feeding condition ,and reverse the machine for several times , –
It can remove the dust and sundries by this way
Drive Spread the lubricant on the drive chain
Shut down
Remove the two side covers
Spread the lubricant on the back chain. Include the drive chain of shred motor, drive chain of shred belt, drive chain of shred system feed roller.
Spread the lubricant on synchronizing pulley every week
